Lenze EVS9321-ES EVS9321-ES EVS9321-ES EVS9321-ES EVS9321-ES EVS9321-ES

approximately 100% depending on the set smoothing and the set interference frequency
suppression.
Table C- 2 Smoothing time depending on the set smoothing level and interference frequency suppressionThe cycle times (1 ms, 1.04 ms and 1.25 ms) result from the configured interference
frequency suppression. The cycle time is independent of the number of configured analog
channels. The values for the analog input channels are detected sequentially in each cycle.
Reference
For more information on conversion time, cycle time and conversion method, refer to the The analog values for all measuring ranges that you can use with the analog on-board I/O
are represented in this appendix.
For cross-product information on "analog value processing", refer to the Analog value
processingThis resolution does not apply to temperature values. The digitalized temperature values are
the result of a conversion in the analog on-board I/O.The following tables list the decimal and hexadecimal values (codes) of the possible current
measuring ranges.
Table C- 8 Current measuring range ±20 mAThe following tables list the decimal and hexadecimal values (codes) of the possible
resistance-type sensor ranges.
Table C- 10 Resistance-type sensors of 150 Ω, 300 Ω and 600 ΩWith suitable parameter assignment, events that occur trigger a diagnostics entry and a
diagnostics interrupt.
Table C- 15 Measured values for wire break diagnostics
Format Parameter assignment Measured values Explanation
S7 • "Wire break" diagnostics enabled
• "Overflow/Underflow" diagnostics
enabled or disabled
("Wire break" diagnostics has a higher
priority than "Overflow/Underflow" diagnostics)
32767 7FFFH "Wire break" or "Cable break" diagnostics
alarm
• "Wire break" diagnostics disabled
• "Overflow/Underflow" diagnostics
enabled
-32767 8000 H • Measured value after leaving the underrange
• Diagnostics alarm "Low limit" violated
• "Wire break" diagnostics disabled
• "Overflow/Underflow" diagnostics
disabled
-32767 8000 H Measured value after leaving the underrangeThe tables below set out the digitalized representation of the output ranges separately for
bipolar and unipolar ranges. The resolution is 16 bits.The tables below list the decimal and hexadecimal values (codes) of the possible voltage
output ranges. This manual contains notices you have to observe in order to ensure your personal safety, as well as to prevent
damage to property. The notices referring to your personal safety are highlighted in the manual by a safety alert
symbol, notices referring only to property damage have no safety alert symbol. These notices shown below are
graded according to the degree of danger.f more than one degree of danger is present, the warning notice representing the highest degree of danger will
be used. A notice warning of injury to persons with a safety alert symbol may also include a warning relating to
property damage.
Qualified Personnel
The product/system described in this documentation may be operated only by personnel qualified for the specific
task in accordance with the relevant documentation, in particular its warning notices and safety instructions.
Qualified personnel are those who, based on their training and experience, are capable of identifying risks and
avoiding potential hazards when working with these products/systems.
Proper use of Siemens products
Note the following:
WARNING
Siemens products may only be used for the applications described in the catalog and in the relevant technical
documentation. If products and components from other manufacturers are used, these must be recommended
or approved by Siemens. Proper transport, storage, installation, assembly, commissioning, operation and
maintenance are required to ensure that the products operate safely and without any problems.