LENZE E82EV552K2C200 E82EV552K2C200 E82EV552K2C200 E82EV552K2C200 E82EV552K2C200

ou will find more information about the SIMATIC ET 200 distributed I/O on the at n the following section, you will create a PROFINET I/O system.
A PROFINET I/O system consists of the PROFINET IO controller and its assigned
PROFINET IO devices:
● The CPU 1511-1 PN you already created is used as PROFINET IO controller.
● The two distributed I/O systems are used as PROFINET IO devices.1. Drag-and-drop a connection from the interface of the IM 155-5 PN ST interface module to
the CPU interface.
2. Create a second connection between the IM 155-6 PN ST interface module and the CPU.
Result
The interface modules are assigned to the CPU as IO devices. Both distributed IO systems
are displayed in the project tree in the "Distributed I/O" folder below the CPU.
A PROFINET I/O system was created automatically in the networking process and its
properties are displayed in the network viewthe following section, you will create input and output modules for the ET 200SP.
Note
You need the server module to operate the input and output modules. These modules will
fail if the server module is missing.
Maximum configuration per potential group
The number of I/O modules that can be used per potential group depends on the following
factors:
1. Total power requirement of all I/O modules operated on this potential group
2. Total power requirement of all loads connected externally to this potential group
The sum of the total power calculated from 1. and 2. cannot exceed the current carrying
capacity of the employed BaseUnit and the load supply voltage.
Set the "Potential group" parameter for a module as followUse potential group of the
left module (default setting)
if the total power consumption of all modules from the left + power
consumption of the module is less than the current carrying
capacity of the BaseUnit
Enable new
potential group
if the total power consumption of all modules from the left + power
consumption of the module is greater than the current carrying
capacity of the BaseUnit
You can find additional information on potential groups in the module manuals such as
SIMATIC ET 200SP DI 8x24VDC HF digital input moduleOpen the device view of ET 200SP.
2. Open the "DI" and "DI16 x DC24V ST" folders in the hardware catalog.
3. Drag-and-drop input module "6ES7 131-6BH00-0BA0" to slot 1 of the rail.
4. Open the "DQ" and "DQ16 x DC24V / 0.5A ST" folders.
5. Drag-and-drop output module "6ES7 132-6BH00-0BA0" to slot 2 of the rail.
6. Open the "Server modules" folder.
7. Drag-and-drop the server module "6ES7 193-6PA00-0AA0" to slot 3 of the raIn the