LENZE E82EV751K4C200 E82EV751K4C200 E82EV751K4C200 E82EV751K4C200 E82EV751K4C200

Table 13- 1 Pulse-shaped disturbances
Pulse-shaped disturbance Test voltage Corresponds
with degree of
severity
Electrostatic discharge in accordance
with IEC 61000-4-2.
Air discharge: ±8 kV
Contact discharge: ±6 kV
3
3
Burst pulses (high-speed transient disturbances)
in accordance with
IEC 61000-4-4.
±2 kV (power supply cable)
±2 kV (signal cable > 30 m)
±1 kV (signal cable < 30 m)
3
3
High-energy single pulse (surge) in accordance with IEC 61000-4-5
External protective circuit required (not for 230 V modules)
You can find more information in the Designing interference-free controllers function
manual.
3 • Asymmetric coupling ±2 kV (power supply cables)
DC with protective elements
±2 kV (signal/data line only > 30 m), with
protective elements
• Symmetric coupling ±1 kV (power supply cable) DC with
protective elements
±1 kV (signal/data line● Approval Standard Class Number 3611, 3600, 3810The R/H redundant system meets the specifications regarding shpings and
storage conditions pursuant to IEC 61131-2. The following information applies to modules
that are shped and/or stored in their original packagingThe R/H redundant system is designed for stationary use in weather-proof locations.
The operating conditions are based on the requirements of DIN IEC 60721-3-3:
● Class 3M3 (mechanical requirements)
● Class 3K3 (climatic requirements)
Test of mechanical ambient conditions
The table below provides important information with respect to the type and scope of the test
of ambient mechanical conditions.
Table 13- 7 Test of mechanical ambient conditionsVibration test according
to IEC 60068-2-6
(Sinus)
Type of oscillation: Frequency sweeps with a rate of change of 1 octave/minute.
5 Hz ≤ f ≤ 8.4 Hz, constant amplitude 7 mm
8.4 Hz ≤ f ≤ 150 Hz, constant acceleration 2 g
Duration of oscillation: 10 frequency sweeps per axis, along each of the 3
mutually perpendicular axes
Shock Shock, tested according

rated voltage Tolerance range
24 V DC 19.2 V DC to 28.8 V DC1)
1) Static value: Generation as functional extra-low voltage with safe electrical isolation in accordance
with IEC 61131-2 or IEC 61010-2-2The following table contains an explanation of the symbols located in your SIMATIC device,
its packaging or the accompanying documentation.The following table contains an explanation of the symbols located in your SIMATIC device,
its packaging or the accompanying documentation.Note that a device of Protection Class III may only be supplied with a protective
low voltage according to the standard SELV/PELV.
IEC 60417-1-5180 "Class III equment"
Be aware that the device is only approved for the industrial field and only for indoor
use. For Zone 2 potentially explosive atmospheres, be aware that the device may only
be used when it is installed in an enclosure with a degree of protection ≥ 54.