 |
| Place of Origin: | Germany |
| Brand Name: | LENZE |
| Certification: | CE |
| Model Number: | E82EV302K4C |
| Minimum Order Quantity: | 1pcs |
|---|---|
| Packaging Details: | carton |
| Delivery Time: | in stock |
| Payment Terms: | T/T, Western Union, MoneyGram |
| Supply Ability: | 100pcs/week |
| LENZE: | LENZE | E82EV302K4C: | E82EV302K4C |
|---|---|---|---|
| Germany: | Germany | Color: | Black |
| Temperature: | 20-90 | Dimension: | 70mm |
| Wire: | Wire |
| automatically shows the image after 60 seconds. To hide the image again, press any key on the displayYou can set the following languages separately for menu and message texts: |
Download the message texts to the CPU as a software component. – To do so, select the "Consistent download" option under "Text libraries" in the "Load preview" dialog |
| You select the required language directly at the display in the "Display" menu or in STEP 7 in the hardware configuration of the CPU under "User interface languages". |
Configure the project language that you want to be displayed as the interface language. – To do so, select a CPU and navigate to the "Multiple languages" area ("Properties > |
| You select the required language directly at the display in the "Display" menu or in STEP 7 in the hardware configuration of the CPU under "User interface languages". |
General > Multilingual support") in the Inspector window. – Assign the required project languages to the interface languages.Please observe the following rules if the redundant system is in the RUN-Solo system state: |
Do not immediately start replacing components.
● Do not immediately switch the failed CPU to the RUN. operating state.
First check the pairing status in the RUN-Solo system stateThis could result in an undefined system state for the redundant system. Both CPUs would
become primary CPUs.
If the R/H redundant system is in the RUN-Solo system state, you must not
immediately switch the backup CPU to the RUN operating state.
Possible cause: No pairing between the two CPUs. Check the pairing status on the display
or on the basis of the diagnostics status or diagnostics buffer.
If there is no pairing, the redundancy connections have been interrupted, for example. In
this case, please note the procedure below.You have the following options for checking the pairing state:
● Directly from the display of the backup CPU.
In the "Overview > Redundancy > Pairing state" menu:
– Paired
– Single paired (X*P*)
– Not paired
– Not paired - Too many partners
– Not paired - Article ID mismatch
– Not paired - Firmware mismatchTo start the pairing, for example when redundancy connections are interrupted, follow these
steps:
1. Set the mode selector for the backup CPU to STOP.
2. R: Repair the PROFINET cables in the PROFINET ring. Insert the PROFINET
cables into the R-CPU interfaces.
H: Repair the fiber-optic cables and synchronization modules. Insert the fiberoptic
cables into the synchronization modules.
3. Check for successful pairing of the redundant system. Please note the information in
"Checking pairing state" above.
4. Switch the backup CPU to the RUN operating state with the mode selector.
Result
The R/H redundant system sOne of the two R/H-CPUs has failed or the R/H-CPU is no longer working.
The R/H redundant system is in the RUN-Solo system state.
