HAROWE 11BRW-300-F-95A 11BRW-300-F-95A 11BRW-300-F-95A 11BRW-300-F-95A 11BRW-300-F-95A

Type of output voltage DC
for signal "1", min. L+ (-0.8 V)
Output current
For signal "1" rated value 0.5 A
For signal "1" permitted range, max. 0.5 A
For signal "0" residual current, max. 0.5 mA
Output delay with resistive load
"0" to "1", max. 100 µs
"1" to "0", max. 500 µs
Parallel switching of 2 outputs
For logical operations Yes
For increased performance No
For redundant activation of a load Yes
Switching frequency
With resistive load, max. 100 Hz
With inductive load, max. 0.5 Hz; acc. to IEC 947-5-1, DC13
With lamp load, max. 10 Hz
Total current of the outputs
Max. current per channel 0.5 A; see additional description in the manual
Max. current per group 4 A; see additional description in the manual
Max. current per module 16 A; see additional description in the manual
Cable length
Cable length shielded, max. 1000 m
Cable length unshielded, max. 600 m
Interrupts/diagnostics/status information
Substitute values can be applied No
Interrupts
Diagnostics interrupt No
Diagnostics alarms
Diagnostics No
Diagnostics indicator LED
RUN LED Yes; green LEDBetween the channels No
Between the channels, in groups of 8
Between the channels and the backplane bus Yes
Permitted potential difference
Between different circuits 75 VDC / 60 VAC (basic isolation)
Isolation
Isolation tested with 707 VDC (type test)
Distributed mode
Prioritized startup Yes
Dimensions
Width 25 mm
Height 147 mm
Depth 129 mm
Weights
Weight, approx. 280 g
Miscellaneous
Note: Supplied incl. 40-pin push-in front connectorThe following graphs show the load capacity of the outputs in relation to the mounting
position and the ambient temperature.The dimensional drawing of the module on the mounting rail, as well as a dimensional
drawing with open front cover, are provided in this appendix. Always observe the specified
dimensions for installation in cabinets, control rooms, etc. In the product "Digital Modules, Analog Modules, Technological Modules, Communication
Modules and Power Supply Modules of the SIMATIC , ET 200MP", Copyright
AG, 2013 - 2014 (hereinafter "Product"), the following Open Source Software is
used either unchanged or in a form that we have modified, and additionally the other License
Software noted below.
Liability for Open Source Software
Open Source Software is provided free of charge. We are liable for the Product including
Open Source Software contained in accordance with the license conditions applicable to the
Product. Any liability for use of Open Source Software beyond the program flow intended for
the Product is explicitly excluded.
We do not provide any technical support for the Product if it has been modified.
Please read the license conditions and copyright notes for Open Source Software as This manual contains notices you have to observe in order to ensure your personal safety, as well as to prevent
damage to property. The notices referring to your personal safety are highlighted in the manual by a safety alert
symbol, notices referring only to property damage have no safety alert symbol. These notices shown