Table B- 13 Valid values for temperature compensation via data record
Temperature unit Dec Hex
Celsius (default) -1450 to 1550 FA56H to 60EH
Fahrenheit (default) -2290 to 3110 F70EH to C26H
Kelvin (default) 1282 to 3276 502H to CCCH
Celsius (climatic) -14500 to 15500 C75CH to 3C8CH
Fahrenheit (climatic) -22900 to 31100 A68CH to 797CH
Kelvin (climatic) 12820 to 32760 3214H to 7FF8H
Additional information
For more information on compensation of the reference junction temperature vThis section shows the analog values for all measuring ranges supported by the AI
4xU/I/RTD/TC ST analog module.
Measured value resolution
Each analog value is written left aligned to the tags. The bits marked with "x" are set to "0".
Note
This resolution does not apply to temperature values. The digitalized temperature values are
the result of a conversion in the analog module.
Table C- 1 Resolution of the analog valuesThe tables below set out the digitized representation of the input ranges by bipolar and
unipolar input ranges. The resolution is 16 bits.The following tables list the decimal and hexadecimal values (codes) of the possible voltage
measuring ranges.
Table C- 4 Voltage measuring ranges ±10 V, ±5 V, ±2.5 V, ±1 V, Voltage measuring ranges ±500 mV, ±250 mV, ±80 mV, and ±50 mVThe following tables list the decimal and hexadecimal values (codes) of the possible current
measuring ranges.
Table C- 7 Current measuring range ±20 mA
Values Current measuring rangeThe following tables list the decimal and hexadecimal values (codes) of the possible
resistance-based sensor ranges.
Table C- 9 Resistance-based sensors of 150 Ω, 300 Ω, 600 Ω, and 6000 ΩWire break" diagnostics enabled
• "Overflow/Underflow" diagnostics
enabled or disabled
("Wire break" diagnostics takes priority
over "Overflow/Underflow" diagnostics)
32767 7FFFH "Wire break" or "Open circuit" diagnostics
alarm
• "Wire break" diagnostics disabled
• "Overflow/Underflow" diagnostics
enabled
-32767 8000 H • Measured value after leaving the undershoot
range
• Diagnostics alarm "Low limit violated"
• "Wire break" diagnostics disabled
• "Overflow/Underflow" diagnostics
disabled
-32767 8000 H Measured value after leaving the undershoot
rangeIn the product "Digital Modules, Analog Modules, Technological Modules, Communication
Modules and Power Supply Modules of the SIMATIC , ET 200MP", Copyright
AG, 2013 - 2014 (hereinafter "Product"), the following Open Source Software is
used either unchanged or in a form that we have modified, and additionally the other License
Software noted below.
Liability for Open Source Software
Open Source Software is provided free of charge. We are liable for the Product including
Open Source Software contained in accordance with the license conditions applicable to the
Product. Any liability for use of Open Source Software beyond the program flow intended for
the Product is explicitly excluded.
We do not provide any technical support for the Product if it has been modified.• You may use and combine the different wiring options for all channels.
• Do not insert the potential jumpers included with the front connector!