Transfer of the date and the programming device/PC time converted to UTC time to the
module
● Program download to CPU
● Operating mode switchover RUN/STOP
● Localization of the CPU by means of LED flashing
● Reading out CPU error information
● Reading the CPU diagnostic buffer
● Reset to factory settings
● Updating the firmware of the CPU and connected modules
You can find the SIMATIC Automation Tool on the InterneWith PRONETA (PROFINET network analysis), you analyze the PROFINET
network during commissioning. PRONETA features two core functions:
● The topology overview independently scans PROFINET and all connected components.
● The IO check is a fast test of the wiring and the module configuration of a system.
You can find PRONETA on the The module has the following technical properties:
● 8 analog inputs
● Voltage or current measuring type can be set per channel
● Resolution 16 bits including sign
● Configurable diagnostics (per channel)
● Hardware interrupt on limit violation can be set per channel (two low and two high limits
per channel)
● High-speed update of measured valueshe module supports the following functions:
You can configure the module with STEP 7 (TIA Portal) and with a GSD file. The
oversampling function requires isochronous mode and can therefore only be configured with
STEP 7 (TIA Portal).
Accessories
The following accessories are supplied with the module and can also be ordered separately
as spare parts:
● Shield bracket
● Shield terminal
● Power supply element
● Labeling strips
● U connector
● Universal front doorThe following component can be ordered separately:
Front connectors, including potential jumpers and cable ties
You can find additional information on accessories in the /ET 200MP Oversampling is defined as the transfer of data in constant bus cycle segments (sub-cycles),
whereby n sub-cycles correspond to one PROFINET bus cycle. The configured number n of
sub-cycles corresponds to one data cycle. Each sub-cycle reads in a measured value.
Oversampling is useful whenever you require acquisition of data with high time resolution but
without using an extremely short PROFINET bus cycle and thus fast CPU cycles.
With oversampling, a PROFINET bus cycle is divided into constant bus sub-cycles:
● One 16-bit value is read in per channel in each sub-cycle.
● The shortest possible sub-cycle is 62.5 μs.
● Sub-cycles are possible in increments of 2 to 16. The following applies here: Isochronous
data cycle / number of sub-cycles ≥ permitted sub-cycle duration (62.5 μs).
Typical areas of applications
Quality-monitoring measurements, for example when recording pressure trends during the
blowing process of PET bottle production.
Requirements
● Firmware version V2.1.0 or higher of the module.
● Isochronous mode has to be set.
Configuration
You configure the oversampling function by means of the sampling rate paramete operating instructions. The STEP 7 online
help supports you in the configuration and programming.
Device information
Product manuals contain a compact description of the module-specific information, such as
properties, wiring diagrams, characteristics and technical specifications.