(0.006170)The following tables list the decimal and hexadecimal values (codes) of the possible
resistance thermometer ranges.
Table C- 11 Thermal resistor Ni x0 GOST Standard (0.006170)The following tables list the decimal and hexadecimal values (codes) of the supported
thermocouples.
Table C- 16 Thermocouple type BThis manual contains notices you have to observe in order to ensure your personal safety, as well as to prevent
damage to property. The notices referring to your personal safety are highlighted in the manual by a safety alert
symbol, notices referring only to property damage have no safety alert symbol. These notices shown below are
graded according to the degree of danger.
DANGER
indicates that death or severe personal injury will result if proper precautions are not taken.
WARNING
indicates that death or severe personal injury may result if proper precautions are not taken.
CAUTION
indicates that minor personal injury can result if proper precautions are not taken.
NOTICE
indicates that property damage can result if proper precautions are not taken.
If more than one degree of danger is present, the warning notice representing the highest degree of danger will
be used. A notice warning of injury to persons with a safety alert symbol may also include a warning relating to
property damage.
Qualified Personnel
The product/system described in this documentation may be operated only by personnel qualified for the specific
task in accordance with the relevant documentation, in particular its warning notices and safety instructions.
Qualified personnel are those who, based on their training and experience, are capable of identifying risks and
avoiding potential hazards when working with these products/systems.
Proper use of products
Note the following:
WARNING
products may only be used for the applications described in the catalog and in the relevant technical
documentation. If products and components from other manufacturers are used, these must be recommended
or approved by . Proper transport, storage, installation, assembly, commissioning, operation and
maintenance are required to ensure that the products operate safely and without any problems. The permissible
ambient conditions must be complied with. The information in the relevant documentation must be observed.
Trademarks
All names identified by ® are registered trademarks of AG. The remaining trademarks in this publication
may be trademarks whose use by third parties for their own purposes could violate the rights of the owner.
Disclaimer of Liability
We have reviewed the contents of this publication to ensure consistency with the hardware and software
described. Since variance cannot be precluded entirely, we cannot guarantee full consistency. However, the
information in this publication is reviewed regularly and any necessary corrections are included in subsequent
editionsThis product manual supplements the system manuals:
● Automation System
● ET 200MP distributed I/O system
Functions that relate in general to the systems are described in these system manuals.
The information provided in this product manual and in the system/function manuals
supports you in commissioning the systems.
Changes compared to previous version
Changes described in this manual, compared to the previous version:
● Detailed information on the module functions, for example, as of which STEP 7 version
the function is supported.
● Diagnostic alarms section revised.
Conventions
The term "CPU" is used in this manual both for the CPUs of