Module is ready.
Flashes Flashes
Hardware defective. Replace the module.
With lamp load, max. 5 W
Load resistance range
Low limit 48 Ω
High limit 12 kΩ
Output voltage
Type of output voltage DC
for signal "1", min. L+ (-0.8 V)
Output current
For signal "1" rated value 0.5 A
For signal "1" permitted range, max. 0.5 A
For signal "0" residual current, max. 0.5 mA
Output delay with resistive load
"0" to "1", max. 100 µs
"1" to "0", max. 500 µs
Parallel switching of 2 outputs
For logical operations Yes
For increased performance No
For redundant activation of a load Yes
Switching frequency
With resistive load, max. 100 Hz
With inductive load, max. 0.5 Hz; acc. to IEC 947-5-1, DC13
With lamp load, max. 10 Hz
Total current of the outputs
Max. current per channelIn the product "Digital Modules, Analog Modules, Technological Modules, Communication
Modules and Power Supply Modules of the SIMATIC , ET 200MP", Copyright
AG, 2013 - 2014 (hereinafter "Product"), the following Open Source Software is
used either unchanged or in a form that we have modified, and additionally the other License
Software noted below.
Liability for Open Source Software

Open Source Software is provided free of charge. We are liable for the Product including
Open Source Software contained in accordance with the license conditions applicable to the
Product. Any liability for use of Open Source Software beyond the program flow intended for
the Product is explicitly excluded.
We do not provide any technical support for the Product if it has been modifiedIf more than one degree of danger is present, the warning notice representing the highest degree of danger will
be used. A notice warning of injury to persons with a safety alert symbol may also include a warning relating to
property damage.
Qualified Personnel
The product/system described in this documentation may be operated only by personnel qualified for the specific
task in accordance with the relevant documentation, in particular its warning notices and safety instructions.
Qualified personnel are those who, based on their training and experience, are capable of identifying risks and
avoiding potential hazards when working with these products/systems.
Proper use of products
Note the following:
WARNING
products may only be used for the applications described in the catalog and in the relevant technical
documentation. If products and components from other manufacturers are used, these must be recommended
or approved by . Proper transport, storage, installation, assembly, commissioning, operation and
maintenance are required to ensure that the products operate safely and without any problems. The permissible
ambient conditions must be complied with. The information in the relevant documentation must be observed.All names identified by ® are registered trademarks of AG. The remaining trademarks in this publication
may be trademarks whose use by third parties for their own purposes could violate the rights