The figure below shows the LED displays (status and error displays) of the DI
16x24VDC/DQ 16x24VDC/0.5A BA.• Verify that the U connectors are inserted. |
|
vCheck to see if too many modules are inserted.Number of inputs 16
Configurable digital inputs No |
|
Sinking/sourcing input Sinking input
Input characteristic curve acc. to IEC 61131, type |
|
3
Yes
Input voltage
Type of input voltage DC
Rated value (DC) 24 V
for signal "0" -30 to +5 V
for signal "1" +11 to +30 V
Input current
for signal "1", typ. 2.7 mA
Input delay (for rated value of input voltage)
For standard inputs
• Configurable No
• with "0" to "1", min. 3 ms
• with "0" to "1", max. 4 ms
• with "1" to "0", min. 3 ms
• with "1" to "0", max. 4 ms
For interrupt inputs
• Configurable No
Cable length
shielded, max. 1000 m
unshielded, max. 600 m
Digital outputs
Number of outputs 16
Sourcing output Yes
Short-circuit protection Yes
• Response threshold, Number of outputs 16
Sourcing output Yes
Short-circuit protection Yes
• Response threshold, typ. 1 A
Limitation of inductive shutdown voltage to L+ (-53 V)
Activation of a digital input Yes
Switching capacity of the outputs
With resistive load, max. 0.5 A
With lamp load, max. 5 W
Load resistance range
Low limit 48 Ω
High limit 12 kΩ
Output voltage
for signal "1", min.For logical operations Yes
For increased performance No
For redundant activation of a load Yes
Switching frequency
With resistive load, max. 100 Hz
With inductive load, max. 0.5 Hz
With lamp load, max. 10 Hz
Total current of the outputs
Current per channel, max. 0.5 A; see additional description in the manual
Current per group, max. 4 A; see additional description in the manual
Current per module, max. 8 A; see additional description in the manual
Cable length
shielded, max. 1000 m
unshielded, max. 600 mMonitoring of supply voltage (PWR LED) Yes; green LED
Channel status display Yes; green LED
For channel diagnostics No
For module diagnostics No
Electrical isolation
Electrical isolation of channels
Between the channels No
Between the channels, in groups of 8
Between the channels and backplane bus Yes
Isolation
Isolation tested with 707 V DC (type test)
Ambient conditions
Ambient temperature during operation
Horizontal mounting position, min. 0 °C
Horizontal mounting position, max. 60 ℃
Vertical mounting position, min. 0 °C
Vertical mounting position, max. 40 °C
Distributed mode
Prioritized startup Yes
DimensionsThe following graphs show the loading capacity of the outputs in relation to the mounting
position of the S71500 automation system/ET 200MP distributed I/O system and the ambient
temperature.The dimensional drawing of the module on the mounting rail, as well as a dimensional
drawing with open front cover, are provided in this appendix. Always observe the specified
dimensions for installation in cabinets, control rooms, eThis manual contains notices you have to observe in order to ensure your personal safety, as well as to prevent
damage to property. The notices referring to your personal safety are highlighted in the manual by a safety alert
symbol, notices referring only to property damage have no safety alert symbol. These notices shown below are
graded according to the degree of dangerIf more than one degree of danger is present, the warning notice representing the highest degree of danger will
be used. A notice warning of injury to persons with a safety alert symbol may also include a warning
