TAMAGAWA TS5200N500 TS5200N500 TS5200N500 TS5200N500 TS5200N500 TS5200N500

TS5200N500

TS3692N42

TS3699N112

TS3699N172

TS3699N232

TS3738N1E7

TS3738N1E7

TS3741N3E8

TS374

TS3762N15E4

TS4126N1017E235

TS4127N1017E215

TS4127N1017E235

TS4231N6E17

TS4231N6E17

TS4244N10E24

TS4244N3E24

TS4502N1000E200

TS4502N1202E200

TS4502N2000E100

TS4503N1000E200

For controllers with balanced areas (e.g. chemical installations, cable cars)
In this case also, the area that is not safety-relevant is controlled with a
standard PLC, whereas a tested fail-safe controller (F or FH) PLC
the safety-relevant areas.
The entire installation is implemented with a fail-safe control system.
• For control equipment with mainly safety-relevant functions (e.g. burner control
systems)
The entire control system is implemented with fail-safe technology
Important Information
Even when electronic control equipment has been configured for maximum design
safety -- e.g. with a multi-channel structure -- it is imperative conform with
instructions given in the operating manual. Incorrect handling can render measures
intended to prevent dangerous faults ineffective, or generate additional sources of
dangerYou can use control and monitoring interfaces with monitor ports from the WinCC
product family. The layout of apparatus and degree of interference are decisive
factors for the interference-free connection of monitors to a PLC. A decisive factor
in the selection of monitor and video cables is the location of the monitor and PLC,
that is, depending on whether these are operated under low-interference or
industrial conditions.
Operation under Low-Interference Conditions
Where a monitor and the programmable controller operate in a low-interference
environment and there is only a short distance between monitor and programmable
controller, they are at almost the same ground potentials. Interference and
disturbance by ground loops are therefore not expected.
In these cases, you can use either TTL or analog signals to drive the monitor.
Digital cables or single-shielded coaxial cables can be used to transmit the video
signals. Note that the braided shield of the coaxial cable serves as the return
conductor and must not be connected to the shield bus. The monitor and
communications processor (CP) are interconnected without additional shielding
and grounding.Where the monitor and programmable controller are operated under harsh
industrial conditions or there is a great distance between monitor and
programmable controller, the apparatus may be at different ground potentials; this,
in turn, can result in interference and disturbances caused by ground loops.
In these cases, double-shielded coaxial cable (triaxial cable) must be used to
transmit the video signal. The inner braided shield of this cable serves as the return