vindependently and continues working with the value in SLOT STS_ENABLE The output sequence is active. (STS_ENABLE always depends on the status of the software enable User resets LD_SLOT and MODE_SLOT, ... Read More
The value in SLOT is transferred with each module cycle. – No acknowledgment bit is available. The value of LD_SLOT defines the interpretation of SLOT (see the table below "Interpretation of the SLOT parameter ... Read More
When you select the direct control of the pulse output (DQA) during a pulse output sequence, the sequence continues to run in the background so that the output sequence is continued as soon as the channel takes ... Read More
Maximum speed The parameter "Maximum speed" is used to define the required maximum speed for your application. The supported value range depends on: ? the signal type selected under "Operating mode" ? the value ... Read More
case of no supply voltage L+ Deactivated Deactivated ctivated Parameter High-speed output ctivated Parameter High-speed output whether you want to use the selected pulse output as high-speed output. The ... Read More
pulse output (DQA)" cannot be selected. 0 (use substitute value 0) 0 1 (use substitute value 1) Diagnostics interrupt No supply voltage L+ The parameter "Missing supply voltage L+" activates the diagnostic ... Read More
A renewed pulse output is only possible after a restart of the output sequence. Minimum pulse duration and minimum interpulse period A pulse duration determined by the technology function or PWM channel which ... Read More
Rising or falling edge of a digital input Comparison values The integrated counter supports 2 comparison values and digital output HSC DQ1 Rising edge of signal N at the encoder input f the counter or measured ... Read More
