ERROR OUT Bool The ERROR bit is TRUE for one scan, after the last request was STATUS OUT Word Execution condition code (Default value: 0) You can provide either the NAME or an ID (ID parameter as an input) of a ... Read More
TS2651N131E78 ERROR OUT Bool The ERROR bit is TRUE for one scan, after the last request was terminated with an error. The error code value at the STATUS parameter is valid only uring the single scan where ERROR ... Read More
You can assign an entire DB (derived from a PLC data type that you assign when the DB is created) or part of a DB (the specified DB element can be any data type, data type structure, PLC data type, or data ... Read More
TS2651N1E78 Guang Zhou Lai Jie Electric Co.,LTD Please contact with “Tommy” for the price TS3653N1E1 TS5641N150 TS2640N321E64 TS4507N1229E200 TS3212N32 RFH102422 TS3679N3E1 TS5208N111E78 TS3617N47E4 TS1508N211 ... Read More
convert, math, or PID box to write the desired pulse width to the appropriate Q word. Digital I/O points assigned to PWM and PTO cannot be forced configuration ("Output addresses" / "Start address:") as needed ... Read More
TS2651N141E78 Bit 14 = 1: PNIO - module disconnected 15 - Bit 14 = 1: PNIO - module disconnected 15 - Bit 18 = 1: Input not available Bit 19 = 1: Output not available 16 to 31 Status information for modules ... Read More
RET_VAL OUT Int Status (condition code) Word, or DWord) or an array of a bit type. STATE1 InOut Variant Buffer that receives the error status of each module: The data type Summary bit: Bit 0 =1, if one of the ... Read More
TS2651N11E78 DeviceStates instruction (Page 299): You can retrieve the operational states for a distributed I/O device within an I/O subsystem. 8.5.2 Diagnostic events for distributed I/O Note ModuleStates ... Read More
associates a time delay interrupt OB subprogram with the time delay timeout event. You can cancel an in-process time delay interrupt before the specified time delay occurs by executing the CAN_DINT instruction. ... Read More
TS5205N454 If the CYCLE time = 0, then the interrupt event is deactivated and the interrupt OB is not executed. If lower and higher priority OBs are called in the same time interval, The PHASE (phase shift) ... Read More
